Some bunny loves you

Mint ears, a coral heart and a smile drawn by you. Layer the paws so your bunny holds its heart.

35 minutes · Ages 6+ with adult help · 11 pages · 12 steps

A flat, layered bunny about 11.8 x 19.2 cm. Cut 17 named paper pieces, follow 12 colour steps, then draw the pupils and smile. No folding or colour printing is needed. Suggested ages 6+ with adult help; allow about 35 minutes.

Preview shop. No payment is collected by this demonstration.

Materials

• 1 A4 or US Letter sheet of MINT paper; 1 sheet of WHITE paper; PINK paper at least 8 x 8 cm; CORAL paper at least 6 x 6 cm. Light paper or card, about 120-160 gsm, works well.
• Child-safe scissors, glue stick, pencil, eraser, ruler and a black felt-tip pen. Protect the table with scrap paper.
• Write part IDs lightly on the backs. Dry-fit before gluing. Put glue only on the overlapping backs. Ask a grown-up to help with small shapes and curved cuts.
• Print only pages 9-11 at Actual size / 100%. Check each 5 cm test bar; a colour printer is not needed.

Inside your PDF

• 11-page English PDF: finished view, preparation, colour instructions and 3 full-size pattern pages
• 12 numbered steps, each with its own colour illustration
• 17 paper pieces with named colours and cut quantities
• Close-up pictures show black pupils with uncoloured white highlights and a W-shaped smile.
• A 5 cm calibration bar on every pattern page; A4 and US Letter supported at 100%